|
Tube threading and soldering are unnecessary. Universal brass compression fittings are designed to solve all fluid distribution problems and provide a complete system of fittings suited to all types of tubing,
cylinders and valves thanks to the flexibility offered by the vast range of accessories: olives, sleeve nuts, reducers, tube adaptors.
All components conform to at least one of the following standards: ISO, CETOP, AFNOR, CNOMO.
Fitting Instructions
The Legris brass compression fitting comprises a body, olive and sleeve nut. Cut the tube square, deburr inner and outer edges. If required, any bending of the tube must be completed prior to
connection. Push the sleeve nut onto the tube. For large diameters, lubricate the inside of the nut to facilitate tightening. Fit the olive onto the end of the tube, after the sleeve nut. Firmly push the
tube fully home against the shoulder of the body of the fitting. Tightening of the nut enables the olive to bite into the tube and secures the fully assembled fitting.
Technical Specification
The table below shows the standard recommended compatibility of tube size, BSP male thread and maximum passage diameter.
|
Tube OD
|
Corresponding BSP Thread
|
Maximum Passage (mm)
|
|
4-5-6
|
G1/8
|
4
|
|
6-8-10
|
G1/4
|
7
|
|
10-12-14
|
G3/8
|
11
|
|
14-15-16-18
|
G1/2
|
14
|
|
18-20-22
|
G3/4
|
18
|
|
22-25-28
|
G1”
|
24
|
|
Suitable for Different Pressure Ranges
- Low, medium comressed air pressure
- Medium hydraulic pressure
- For compressed air, fuel oil, hydrocarbon, water...etc.
Extensive Connection in all Industrial Fields
- many connection possibilities
- direct assembly, without soldering or tube preparation
Use to Connect Different Types of Tubing
- Copper to brass
- Plastic (nylon, polyurethane, teflon, PVC...)
- Steel
- Rubber
A Large Range for many Applications
- 18 different body configurations from 4mm to 28mm
- many accessories
- for use with BSP parallel threads with nitrile or bi-material seal, metric parallel threads, BSP taper threads and NPT threads
|
